EGU21-9574
https://doi.org/10.5194/egusphere-egu21-9574
EGU General Assembly 2021
© Author(s) 2021. This work is distributed under
the Creative Commons Attribution 4.0 License.

Characterization of windblown sand transport in open field conditions through wind-sand tunnel testing and computational simulation

Lorenzo Raffaele1,3, Nicolas Coste3,2, Andrea Lo Giudice3,2, Gertjan Glabeke1, and Jeroen van Beeck1
Lorenzo Raffaele et al.
  • 1von Karman Institute for Fluid Dynamics, Environmental and Applied Fluid Dynamics Department, Belgium (lorenzo.raffaele@vki.ac.be)
  • 2Optiflow company, France
  • 3Windblown Sand Modelling and Mitigation joint research group, Italy-France

Aeolian sediment transport in desert and sandy coastal environments affects civil structures and infrastructures, such as pipelines, industrial facilities, towns, single buildings, farms, roads, and railways [1]. The wind flow interacts with surface-mounted obstacles of any kind inducing sand erosion, transport, and sedimentation around them. This can lead to detrimental effects such as the loss of functionality of the endangered structure or infrastructure, or even danger for users when structural failure is involved [2]. In order to cope with the effects above, the demand for the characterization of aeolian sand transport and the design of Sand Mitigation Measures (SMMs) has grown in the last decade and is expected to further increase in the next years [1]. The multiphase and multiscale nature of the aeolian flow ranging from the sand grain diameters to the obstacle characteristic lengths make the problem only tractable by means of physical experiments and computational simulations. On the one hand, in-situ full scale field tests are expensive, time-consuming, and subject to environmental setup conditions difficult to control. On the other hand, numerical models shall be carefully validated against physical experiments. Hence, experimental Wind-Sand Tunnel Tests (WSTTs) are often carried out.

In this study, windblown sand transport on flat ground is reproduced by means of WSTTs carried out in the wind tunnel L-1B of von Karman Institute for Fluid Dynamics. The aim of WSTTs is twofold. On one hand, they are intended to characterize the incoming sand flux in open field conditions. On the other hand, they allow to properly tune cheaper Wind-Sand Computational Simulations [3], so as to assess the performance of SMMs in full-scale. The wind tunnel setup implements a uniform 5-meter-long sand fetch as sand source. The wind speed boundary layer and sand flux saltation layer are characterized through 2D Particle Image Velocimetry (PIV) and Particle Tracking Velocimetry (PTV) techniques, respectively. Wind flow and sand transport state variables are assessed along the sand fetch by setting the wind speed equal to 1.3, 1.5, 2 times the threshold one, and by assessing the influence of a monoplane grid installed at the inlet of the wind tunnel testing sections. Results from WSTTs are critically discussed by investigating the effects induced by the sand fetch length, wind speed, and turbulence intensity on the sand transport. Finally, a Eulerian multiphase computational fluid dynamics model is tuned in order to reproduce the obtained results.

References

[1] Bruno L, Horvat M, Raffaele L. Windblown sand along railway infrastructures: a review of challenges and mitigation measures. J Wind Eng Ind Aerodynam 2018;177:340–65.
[2] Raffaele L, Bruno L. Windblown sand action on civil structures: Definition and probabilistic modelling. Eng Struct 2019;178:88-101.
[3] Lo Giudice A, Preziosi L. A fully Eulerian multiphase model of windblown sand coupled with morphodynamic evolution: Erosion, transport, deposition, and avalanching. Appl Math Model 2020;79:68-84.

How to cite: Raffaele, L., Coste, N., Lo Giudice, A., Glabeke, G., and van Beeck, J.: Characterization of windblown sand transport in open field conditions through wind-sand tunnel testing and computational simulation, EGU General Assembly 2021, online, 19–30 Apr 2021, EGU21-9574, https://doi.org/10.5194/egusphere-egu21-9574, 2021.