EGU22-5876
https://doi.org/10.5194/egusphere-egu22-5876
EGU General Assembly 2022
© Author(s) 2022. This work is distributed under
the Creative Commons Attribution 4.0 License.

Soil structure changes of engineered soils in bioretention cell

Petra Heckova1,2, Michal Snehota1,2, John Koestel3, Ales Klement4, and Radka Kodesova4
Petra Heckova et al.
  • 1Faculty of Civil Engineering, Czech Technical University in Prague, Prague, Czech Republic (petra.heckova@cvut.cz)
  • 2University Centre for Energy Efficient Buildings, Czech Technical University in Prague, Bustehrad, Czech Republic
  • 3Soil Quality and Soil Use, Agroscope Reckenholz, Zürich, Switzerland
  • 4Czech University of Life Sciences Prague, Prague, Czech Republic

Engineered soils play an important role in urban hydrology e.g. in the functioning of green roofs and stormwater bioretention cells. Water infiltration, colloid transport, and heat transport are affected by changes in pore system geometry particularly due to the development of macropores and clogging by particles. The rate of pedogenesis is often faster than in natural soils due to higher loads of particles as well as by extreme water regimes. In the presented research we assess the temporal changes of soil structure of engineered soils in typical bioretention beds by conducting field scale and laboratory experiments. The aim is to elucidate changes in bioretention cell performance by studying the structural changes of soils at the microscale by invasive and noninvasive methods. Noninvasive visualization methods such as computed microtomography (CT), are an effective mean of soil structure assessment. X-ray CT is capable to investigate soil in terms of structure development, pore-clogging and pore geometry deformations.

Two identical bioretention cells were established in December 2017. The first bioretention cell (BC1) collects the stormwater from the roof of the nearby experimental building (roof area 38 m2). The second bioretention cell BC2 is supplied from a tank using a controlled pump system for simulating artificial rainfall. Each BC is 2.4 m wide and 4.0 m long. The 30 cm thick biofilter soil mixture is composed of 50% sand, 30% compost, and 20% topsoil. Bioretention cells are isolated from the surrounding soil by a waterproof membrane. The regular soil sampling program was initiated in 2018 in order to visualize and quantify the soil structure and internal pore geometry of samples. Undistributed samples were collected from the surface of the filter layer twice a year from each BC. The aluminum sampling cylinders had an internal diameter and height of 29 mm. Three batches of samples were taken during three years. The first set of 24 undisturbed samples was collected upon planting in June 2018, while the second set of 24 samples was taken after the end of the first vegetation period in November 2018. The second and third batches, each of 48 samples, were taken in 2019 and 2020 in the same period as in the first year.  Those collected samples were scanned by (CT) imaging.

The analysis performed by SoilJ package shows the initial decrease of macroporosity during the first season as a result of soil consolidation and subsequent further development of the soil's pore system.

How to cite: Heckova, P., Snehota, M., Koestel, J., Klement, A., and Kodesova, R.: Soil structure changes of engineered soils in bioretention cell, EGU General Assembly 2022, Vienna, Austria, 23–27 May 2022, EGU22-5876, https://doi.org/10.5194/egusphere-egu22-5876, 2022.