Dynamic damage in dry and wet rocks monitored by ultra-fast synchrotron imaging

During earthquake propagation, a shock wave damages rocks at the rupture tip, creating numerous microfractures and altering the mechanical properties of fault zone rocks. This damage, which occurs dynamically at the millisecond time scale, controls rock strength during earthquake slip that occurs in the wake of rupture propagation. How the presence of water and the initial porosity of the rock control damage during high strain rate deformation remains an open question. We have performed a series of shock experiments using a split Hopkinson pressure bar apparatus installed at the European Synchrotron Radiation Facility. Using two ultra-fast cameras synchronized with the X-ray bunches of the synchrotron; we imaged deformation with microsecond time resolution on centimetre-scale core samples during shock wave damage. We deformed dry and water saturated low porosity Westerly granite and porous Berea sandstone samples. Several samples were surrounded by a thin aluminium jacket allowing recovering them after deformation and image them using X-ray microtomography with micrometre spatial resolution. Results confirm previous studies that have shown that rock pulverization occurs above a threshold strain rate produced by the shock wave. Water saturated samples are consistently weaker than dry samples as they pulverize under lower peak stress. Analyses of rock microstructure acquired using the ultrafast cameras and X-ray microtomography data shed light on the micro-mechanisms of damage production. Either the entire sample pulverized (Westerly granite) or a compaction of the sample occurred before shear zones were dynamically produced (Berea sandstone). These results demonstrate fundamental differences in dynamic damage production in crystalline and porous dry and wet rocks. Our data unravel mechanisms of gouge production before any significant slip has occurred on a fault, which control the shear strength during earthquake slip.