EGU24-61, updated on 08 Mar 2024
https://doi.org/10.5194/egusphere-egu24-61
EGU General Assembly 2024
© Author(s) 2024. This work is distributed under
the Creative Commons Attribution 4.0 License.

Multi-Offset Radio-Echo Sounding for Estimation of Englacial and Subglacial Thermal Conditions and Material Properties

Daniel May1, Dustin Schroeder1,2, Paul Summers1, Thomas Teisberg2, Anna Broome2, and Nicole Bienert3
Daniel May et al.
  • 1Department of Geophysics, Stanford University, Stanford, CA, United States of America
  • 2Department of Electrical Engineering, Stanford University, Stanford, CA, United States of America
  • 3Ming Hsieh Department of Electrical and Computer Engineering, University of Southern California, Los Angeles, CA, United States of America

Radio-echo sounding (RES) is a widely used tool in the field of glaciology with which critical information about englacial and subglacial conditions can be derived. However, RES observations have historically been limited to zero-offset or small-offset surveys, typically employing one transmitting and one receiving antenna. The poor spatial and azimuthal coverage of the subsurface associated with these sparse geometries limits the ability to robustly constrain key englacial and subglacial properties including ice temperature, bed material composition, water content, ice fabric, and firn density. Furthermore, using radar only in zero- or small-offset configurations limits its potential to provide high resolution imaging of bed geometry. The maximum achievable offset in ground-based radar surveys is typically limited by the relatively high-loss coaxial cable which connects the radar transmitter and receiver. To overcome this limitation, two multi-offset ground-based radar systems, both built around an autonomous phase-sensitive radio-echo sounder (ApRES) as a transmitter, have been developed and deployed by the Radio Glaciology Group at Stanford. The first system forgoes cabled connection between a transmitting ApRES unit and a software-defined radio (SDR) based receiver, instead relying on a post-acquisition processing flow to ensure coherent summation of repeated measurements to achieve sufficient signal-to-noise ratios. The second system replaces the standard high-loss coaxial cable with low-loss fiber optic cable in order to extend the maximum achievable offset between transmitter and receiver. This requires outfitting the ApRES radar system with hardware to convert radio-frequency signals into optical signals that can be transmitted over fiber optic cable (RFoF). Both systems were deployed during the 2023-24 Antarctic field season as part of the Thwaites Interdisciplinary Margin Evolution project in order to collect multi-offset RES data on both floating and grounded ice. These surveys are aimed at detecting englacial temperature anomalies and the estimation of dielectric properties of englacial and subglacial materials through amplitude-versus-offset analysis of radar data. The dense multi-offset coverage in surveys described here was built up by frequent repositioning of only four SDR-based and one ApRES-based receiver; however, future surveys with these systems could have 10s or 100s of radar receivers simultaneously recording, allowing for survey geometries commonly employed in active source seismic imaging to be applied to radar imaging. 

How to cite: May, D., Schroeder, D., Summers, P., Teisberg, T., Broome, A., and Bienert, N.: Multi-Offset Radio-Echo Sounding for Estimation of Englacial and Subglacial Thermal Conditions and Material Properties, EGU General Assembly 2024, Vienna, Austria, 14–19 Apr 2024, EGU24-61, https://doi.org/10.5194/egusphere-egu24-61, 2024.